Okay, this one was made some time ago. Really even some months ago! But I realised while going through my photo folders that I never showed it.
So: Here it is! ^^
The USB stick had a metal case so I really carefully cut the real USB stick out of it. It is a little bit difficult because you have to use a really sharp knife or in my case a scalpell and the used glue is very hard. It is a little bit like carving ^^ But afterwards I just removed all plastic stuff and the electronics and was left with the metall. This I covered with polymer clay (fimo), put some stamps carefully in it and baked it. For the outer layer I used golden polymer clay (I think with the gold I even mixed fimo and prado clay because the gold of prado is more intense than fimo) and a little bit of white transparent (just fimo) polymer clay for the end. There originally was some plastic which I throw away. Due to the transparency of the clay after baking (a little bit like satin / milk glass) you can see the red light glowing through when the USB stick is used ^^
The covered metall case was baked before the tentacles were added. Not too long, just 10 to 15 minutes, but enough that you won't break it while adding the tentacles on top. The tentacles are made out of copper polymer clay (this time really just fimo).
Again, baking all the polymer clay.
Afterwards just covering the whole with some acrylic paint and afterwards wiped off with some soft fabric. It bring the structures really out! But either work fast or just in small areas: acrylic paint dries fast!
At last all was covered with a thick layer of transparent laquer.
And finally a blog entry with tentacles again! :)
0 comments:
Post a Comment